Why is the weight readout wrong on my Sartorius Scales?
If the weight readout on your Sartorius Scales is obviously wrong, it may be due to a lack of calibration or taring. Try calibrating the balance first. If that doesn't work, ensure you tare the balance before weighing your sample.
What to do if the weight readout changes constantly on Sartorius Scales?
If the weight readout on your Sartorius Scales changes constantly or shows “BUSY”, unstable ambient conditions, excessive vibration, drafts, or an unstable sample weight could be the cause. Try setting up the balance in another area to avoid vibration or drafts. You can also access the menu to adjust the code for your weighing environment.
What does CE mean on Sartorius Scales?
If your Sartorius Scales displays “CE”, it could mean that the Cal key wasn't pressed when the display read zero, or the balance is overloaded. Try pressing the tare control. If that doesn't work, unload the balance.
What to do if Sartorius L2200P Scales weight display shows H?
If the weight display on your Sartorius Scales shows “H”, it means the load exceeds the balance's capacity. Unload the balance to resolve this issue.
How to fix no segments appearing in the weight display of Sartorius L2200P Scales?
If no segments appear in the weight display of your Sartorius Scales, check the power supply and ensure the connecting cable is properly plugged into the balance. If there is no line voltage available, check the power supply. If the connecting cable is not plugged into the balance, plug in the cable.
What to do if weight display shows “L” or “CH 2” on Sartorius L2200P Scales?
If the weight display on your Sartorius Scales shows “L” or “CH 2”, it indicates that the weighing pan or the pan adapter are not correctly positioned. Make sure to properly position the pan and the pan adapter.
Procedure for calibrating the balance using a calibration weight and the CAL key.
Steps to access the balance operating program menu by pressing ON/OFF and Tare keys.
Procedure to change menu codes using the tare control to select digits and confirm settings.
Solutions for problems like missing segments or error codes 'L', 'CH 2', or 'H' on the display.
Troubleshooting for constant readouts, 'BUSY' message, 'CE' error, or inaccurate weight.
General| Maximum Capacity | 2200 g |
|---|---|
| Readability | 0.01 g |
| Pan Size | Ø 150 mm |
| Calibration | External |
| Display | LCD |
| Stabilization time (typical) | 2 seconds |
| Power Supply | AC adapter |
| Interface | RS-232 |
| Operating Temperature | +10 °C to +40 °C |
| Repeatability | ±0.01 g |
| Linearity | ±0.02 g |
To Next Page