10
Balance Operating Program
The balance operating program lets you adapt your balance to
various ambient conditions and to different weighing require-
ments, and select the weight unit(s) commonly used in your
country. At the factory, we have set the codes for a Standard
program, which is protected by a locking function to prevent ac-
cidental changes.
The
"menu code"
contains the information of the operating
program, lt consists of three digits, known as the page (1st
digit), the line (2nd digit) and the word (3rd digit) in "com-
puterese."
How to access the menu of the balance operating program:
With the balance turned off (STANDBY state), hold down the
tare control
(5)
and briefly press the ON/OFF key
(3)
.
Upon completion of the automatic self-test, release the tare
control as soon as "CH5" is displayed. The Status of the bal-
ance operating program will appear in the weight display:
"L" Stands for the list mode. In this mode, you can check the
menu code settings, but you cannot program new menu codes.
lf you wish to change a program menu code, you must first
unlock the menu access switch to access the program menu.
To do so, remove the protective cap located on the front right of
your balance and slide the menu access switch
(6)
in the direc-
tion of the arrow.
The display will indicate "C," which Stands for the change
mode, meaning you can now change the menu code settings.
To Next Page
Loading...