7
Operation
The weight display provides the following special Status mes-
sages for your information:
BUSY
The processor is still busy processing a function and will not ac-
cept any other commands to perform functions at this time.
STANDBY
The display has been turned off with the ON/OFF key
(3)
, and
the balance is now in the STANDBY mode and ready to operate
without
warm u p.
POWER OFF
The balance was disconnected from line power (reconnection to
line power after the balance was unplugged, power failure).
CAL
The calibration function has been activated.
In addition to grams, this balance gives you a variety of
other menu-definable international weight unit options.
Select the weight unit you need from the table of the menu op-
tions for the balance operating program, and set the appropriate
code as described in the section "Balance Operating Program."
To Next Page
Loading...