Need help?Do you have a question about the Sartorius Master Pro LP12000S and is the answer not in the manual?
General| Maximum Capacity | 12000 g |
|---|---|
| Readability | 0.1 g |
| Calibration | External |
| Display | LCD |
| Repeatability | 0.1 g |
| Linearity | ±0.2 g |
| Interface | RS-232 |
| Power Supply | AC Adapter |
| Operating Temperature | +10°C to +30°C |
Explains the purpose of balance keys (TARE, SETUP, etc.).
How to enter and exit the service mode.
How to enter and exit the service mode.
List of adjustment options available in service mode.
Procedure to input specific linearization weights.
Steps to perform external linearization after weight input.
Steps to perform external linearization after weight input.
Procedure for internal span adjustment using built-in weight.
How to input weights for external span adjustment.
Performing span adjustment using pre-defined weights.
Procedure for replacing the internal calibration weight.
Factors to check for calibration (preload, span, etc.).
How to check and adjust the preload value.
Steps to adjust the preload for different balance types.
Procedure to test and calculate reproducibility.
Procedure to check off-center load.
Performing 3-point adjustment for brass systems.
Adjustment procedure for large single-casting block systems.
How to check span accuracy using certified weights.
Procedures for checking linearity based on resolution.
Linearity check for lower resolution balances.
To Next Page