Why is the pressure empty on my SATA Measuring Instruments?
The pressure might be empty in your SATA Measuring Instruments because the display has improperly snapped in. Try sliding in the display dock until it snaps. Alternatively, the battery might be empty, in which case you should replace it.
What to do if the display of SATA Measuring Instruments cannot be removed?
If the display of your SATA Measuring Instruments is difficult to remove, ensure the regulation wing is in the horizontal center position. Also, check if the slide-in groove is clogged and clean it if necessary. Make sure the locking clip has snapped in by pressing it. Avoid soaking the special O-ring in solvent, as this can cause it to swell.
What to do if the SATA Measuring Instruments display does not snap in?
If the display of your SATA Measuring Instruments does not snap in, the locking clip might be damaged and need replacement. Another possibility is that the slide-in groove of the SATA adam 2 dock is clogged or damaged. Try cleaning the groove, or replace the dock.
Why is there an air leak in my SATA Measuring Instruments between display and connection module SATA adam 2 dock / adam 2 mini dock?
An air leak between the display and connection module in your SATA Measuring Instruments could be due to a missing or damaged O-ring beneath the locking clip. Replace the O-ring to resolve this issue.
What to do if air leaks from the ball valve of SATA Measuring Instruments?
If air leaks from the ball valve of your SATA Measuring Instruments when using it without the display, the ball valve might be clogged. Try cleaning the ball valve.
Why is the digital display either black or blurred on SATA Measuring Instruments?
The digital display on your SATA Measuring Instruments might be black or blurred because it has been excessively exposed to cleaning solution. Cleaning and replacement of the digital unit may be required.
Read all safety instructions carefully before using the device and follow mandatory measures.
Provides specific safety advice, including regulations, skilled personnel use, and avoiding damaged parts.
Mandatory use of approved breathing, eye protection, and suitable gloves, overall, and shoes.
Details approved use in explosive zones 1 and 2 and prohibited operations.
Instructions for removing and attaching the display unit to the spray gun dock.
Guide on how to adjust the spray gun's inlet pressure using the regulation wing.
General| Brand | SATA |
|---|---|
| Model | adam 2 Series |
| Category | Measuring Instruments |
| Language | English |
To Next Page
