AE5105/AE5105-3
22
中文
EN
Chapter I Safety Precautions
- Make sure that you have read the User's Manual completely including relevant instructions on installation, operation
and safety before operating the lift.
- Do not use the lift if any abnormality is found in the lift.
- Do not overload the lift (rated capacity: 4,000kg).
- Put the four bracket arms aside to ensure that the track is barrier-free before driving to the entry position. Do not
kick the bracket arm as this may damage the bracket arm teeth.
- The lift can be operated by trained personnel only. The vehicle customer or the inexperienced person is prohibited
from operating the lift at will.
- The rubber tray of the lift bracket arm must have contact with the support point of the vehicle; otherwise, the vehicle
chassis may be damaged. (It is recommended to consult the vehicle manufacturer by telephone if the location of the
support point is not clear.)
- Ensure that all bracket arm teeth are engaged successfully before lifting the vehicle.
- Always lift the vehicle with all the four bracket arms at the same time. Never lift the vehicle with less than 4 bracket arms.
- Be sure to perform mechanical locking after the vehicle is lifted. It is forbidden to work under the vehicle before
mechanical locking is performed.
- The centre-of-gravity position of the vehicle may change when you install or remove any automobile component or
push the vehicle forward and backward. To ensure safety, four independent brackets should be applied to improve the
stability of the vehicle.
- Keep the area around the lift clean and tidy as any oil stain or obstacle may pose a safety risk.
- Never lift the vehicle with people in it.
- Make sure there is no obstacle under the vehicle before lowering it.
- Move the bracket arms back to original positions and ensure that they will not interfere with the vehicle before driving
away from the lift.
- Do not remove any hydraulic component when the hydraulic system is under pressure.
- Do not put your hands at such dangerous positions as safety block, wire rope, gap between sliding table and post,
chain, electrical connection, etc.
- Do not use the product outdoors as it is only suitable for indoor use.
- The short bracket arm is installed in the front while the long bracket arm is installed in the rear. (as most vehicles are
equipped with front engine)
- The safety rope must be firm. When the safety handle is pulled, the safety blocks of the main and auxiliary posts must
be opened completely and synchronously.
- Always wear safety shoes during operation.
- The whole machine is guaranteed for one year.
To Next Page
Loading...