BG0441 REV.A9 ENGLISH PM130 PLUS QuickStart www.satec-global.com
PM130 PLUS Quick Start Manual
This Quick Start Manual is a short guide on how to mount, connect, configure and operate the
PM130 PLUS. It is not intended to replace reading the full User Manual – and particularly the
safety precautions. The manual is available on the Product Documentation CD.
Mounting, electrical connection and settings of the PM130 shall be made in
accordance with all applicable laws and/or regulations and be performed by
authorized personnel only.
MOUNTING
Position the PM130 meter in 92×92mm square or 4” round cutout (Figure 1). If two PM130 are
positioned side by side, keep at least 150mm (5.9”) between their centers to allow installation
of add-on modules (140mm/5.5” if only small form modules will be used).
Attach the PM130 unit using washers and nuts. Make sure that the unit is securely attached
into the wall or cabinet fixture.
To Next Page
Need help?
General
