Satel Versa - Operating the Alarm System with Keypad

SATEL VERSA 7
If you want to see the status of all zones which you can inhibit/unbypass, press or
. The numbers around the display enable identification of the zones. Use the and
keys to move the cursor. To inhibit/unbypass a zone, hover the cursor over it and
press any numeric key. If you want to restore the previous way of presentation of the zone
list, press or .
Press to quit the function. The zones will be inhibited/unbypassed.
LED keypad
The state of zones is illustrated by LEDs designated by numbers. The steady-on LEDs
indicate which zones are inhibited or isolated. The blinking (flashing) LED means that the
cursor is situated there. Use the and keys to move the cursor. The cursor may
only be moved over the LEDs corresponding to the zones which can be bypassed or
unbypassed. Press any digit-bearing key to change the LED status:
LED ON – the zone is to be inhibited,
LED OFF – the zone is to be unbypassed.
Press to quit the function. The zones will be inhibited/unbypassed.
Zone isolating
The isolated zone will remain bypassed until it is unbypassed by the user.
Enter the user menu and press in turn . Information on the bypassed
zones will be displayed. How it will be presented depends on the type of keypad.
LCD keypad
The way of indicating the zone state and the procedure are identical to those used for
inhibiting the zones, but pressing any number key will change the displayed symbol to one of
the following symbols:
– the zone is to be isolated,
– the zone is to be unbypassed.
LED keypad
The way of indicating the zone status and the procedure are identical to those used for zone
inhibiting.
1.8.3 Viewing the event log
The function is only available in the LCD keypad.
Enter the user menu and press in turn . The last event that occurred in the
system will be displayed. The event description includes the time of its occurrence, its name
and additional information, e.g. the partition in which the event took place, the zone which
caused the event, etc. The additional information appears automatically a few seconds after
the event is displayed. Press or for the additional information to be displayed
sooner. To scroll through the event log, use the and keys.
1.8.4 Checking the troubles / system state
When the LED is blinking, you can check what caused this signaling. Enter the user
menu and press in turn . The LCD keypad presents information on the display.
To scroll through the list, use the and keys. In the LED keypad, information on
troubles will be presented by means of LEDs (for description of the LEDs, please refer to the
LED keypad user manual).