Satel Versa - Control Panel Compliance with EN 50131 Standard

6 VERSA SATEL
1.6 Turning the CHIME on /off
The CHIME is five short sounds by means of which the keypad will inform you e.g. that
a door / window is open, when the system is disarmed. The installer defines which zones of
the alarm system can trigger the CHIME and whether it can be turned on/off by the users.
Press and hold down for about 3 seconds to turn on or off the CHIME signaling.
1.7 Simple auto-arming deferment
Partition can be armed automatically by the timer on specific days at specific time. If the
control panel is properly configured by the installer, auto-arming can be easily postponed
from the LCD keypad during the auto-arming delay countdown. During the auto-arming delay
countdown the keypad displays a suitable message and, additionally, an audible signal can
be emitted.
Press the key twice to defer the auto-arming.
1.8 User menu
Enter the code and press to get access to the user menu. The list of available
functions depends on your rights, as well as on the state and configuration of the system.
In order to quit the function and/or user menu, press . The keypad will quit the menu
automatically, if 2 minutes have elapsed since the last keypress.
All user functions are described in the full user manual. Only a few selected functions are
discussed below.
1.8.1 Change own code
1. Enter the user menu and press in turn .
2. Enter the new code, and then press .
1.8.2 Zone bypassing
If a zone is not to trigger alarm, you can bypass it, when the partition to which the zone
belongs is disarmed. Zone bypassing is useful, for example, when you want to leave
a window open when the system is armed or when a detector connected to the zone is out of
order and sets off false alarms.
Zone inhibiting
The inhibited zone will remain bypassed until disarming the partition it belongs to, or until
unbypassing the zone by the user.
Enter the user menu and press in turn . Information on the bypassed
zones will be displayed. How it will be presented depends on the type of keypad.
LCD keypad
Shown in the upper line of the display will be a message to inform you that the zone is
bypassed, and in the lower line – the zone name. You can scroll through the zone list using
the and keys. There is a symbol in the upper right corner of the display:
– zone is not bypassed,
– zone is inhibited,
– zone is isolated.
Press any number key to change the displayed symbol to one of the following symbols:
– the zone is to be inhibited,
– the zone is to be unbypassed.