4 VERSA SATEL
1.1 Codes
Operating the alarm system by means of the keypad is possible after entering the code. Only
some functions can be run without the code being entered.
Do not make your code available to other people.
1.1.1 Factory default codes
By default, the following codes are preprogrammed in the control panel:
user 30 code: 1111
service code: 12345
The factory default codes should be changed before you start using your alarm
system (see: “Change own code”).
1.2 Proximity cards
The VERSA-LCDR and VERSA-LCDM-WRL keypads have a built-in proximity card reader.
You can use proximity cards (tags or other 125 kHz passive transponders) to:
– arm the system,
– disarm the system and/or clear alarm,
– toggle the state of the devices connected to the alarm system outputs.
The reader in VERSA-LCDM-WRL keypad is enabled:
− for 5 seconds after disappearance of the connection establishment message (the
message is displayed after the keypad is activated by pressing any key),
− for 20 seconds after pressing the and keys simultaneously.
1.3 Arming
1.3.1 Arming without partition selection
Enter the code, and then press:
- to arm in full mode,
- to arm in day mode,
- to arm in night mode.
The partitions to which you have access will be armed.
1.3.2 Arming the selected partition
1. Indicate the partition which is to be armed (press one of the keys: - partition 1;
- partition 2).
2. Select the arming mode (press one of the keys: - full arming; - day arming;
- night arming). Backlight of the keys will start blinking, which indicates that the
code must be entered.
3. Enter the code.
4. Press the key or press again the key corresponding to the selected arming mode.
When the quick arming is available, the steps 3 and 4 are skipped.
1.3.3 Quick arming
The installer may permit arming without entering the code.
To Next Page
Loading...
