Satel Versa - Page 5

SATEL VERSA 3
Arming without partition selection
[CODE] - full arming
[CODE]
- night arming
[CODE]
- day arming
Arming Partition 1
[CODE]
- full arming
[CODE] - night arming
[CODE] - day arming
Arming Partition 2
[CODE] - full arming
[CODE] - night arming
[CODE] - day arming
Disarming and/or alarm clearing
[CODE] - in both partitions
[CODE] - in partition 1
[CODE] - in partition 2
Quick arming
- partition 1 full arming
- partition 1 night arming
- partition 1 day arming
- partition 2 full arming
- partition 2 night arming
- partition 2 day arming
or - both partitions full
arming
or - both partitions night
arming
or - both partitions day
arming
Quick control of outputs
[number key] - activating output
[number key]
- deactivating output
Triggering the alarm from keypad
fire alarm - press for 3 seconds
panic alarm - press
for 3 seconds
medical alarm - press
for 3 seconds
Turning the CHIME on /off
press for 3 seconds
User menu
[CODE] - entering the user menu, in
which the following submenus and functions
are available:
[1#] Change code
[2] Users
[21#] New user
[22#] Edit user
[23#] Remove user
[3#] Abort v.msg.
[4] Bypasses
[41#] Inhibit
[42#] Isolate
[5#] Event log [LCD keypad only]
[6] Settings
[61#] A-arm defer.
[62#] RTC clock
[63#] Timers
[64#] Tel. numbers
[65#] Msg.clr.codes
[7#] System state
[8#] Control
[9] Tests
[91#] Zone test
[92#] Output test
[93#] Wireless sig.
[94#] Manual MS tst
[95#] MS1 test
[96#] MS2 test
[97#] VERSA version
[98#] Expander ver.
[99#] Supply volt.
[90#] Outputs reset
[0] Service
[00#] Service mode
[01#] Start DwnlTEL
[03#] Start DwnlRS
[04#] FinishDwnlRS
[05#] Serv. access
[06#] Access time
[07#] ETHM-1DLOADX
Quick inspection of partition status
press for 3 seconds
Simple auto-arming deferment
press twice