SATO CG408 - Page 20

Section 3: Basic Specifications
Page 3-2 CG4 Series Quick Guide
Label size Label
Continuous type
Width: 0.87 to 4.21 in. (Backing paper 0.98 to 4.33 in.); 22 to 107 mm (Backing
paper 25 to 110 mm)
Pitch: 0.28 to 11.81 in. (Backing paper 0.39 to 11.93 in.); 7 to 300 mm (Backing
paper 10 to 303 mm)
Cutter type
Width: 0.87 to 4.21 in (Backing paper 0.98 to 4.33 in.); 22 to 107 mm (Backing
paper 25 to 110 mm)
Pitch: 0.87 to 11.81 in. (Backing paper 0.98 to 11.93 in.); 22 to 300 mm (Backing
paper 25 to 303 mm)
Dispenser type
Width: 0.87 to 4.21 in. (Backing paper 0.98 to 4.33 in.); 22 to 107 mm (Backing
paper 25 to 110 mm)
Pitch: 0.87 to 3.94 in. (Backing paper 0.98 to 4.06 in.); 22 to 100 mm (Backing
paper 25 to 103 mm)
Tear-off type
Width: 0.87 to 4.21 in. (Backing paper 0.98 to 4.33 in.); 22 to 107 mm (Backing
paper 25 to 110 mm)
Pitch: 0.87 to 11.81in. (Backing paper 0.98 to 11.93 in.); 22 to 300 mm (Backing
paper 25 to 303 mm)
Linerless type (label without backing paper)
Width: 0.87 to 4.33 in.;22 to 110 mm
Pitch: 0.87 to 3.94 in.; 22 to 100 mm
Non-adhesive label
Continuous type
Width: 0.98 to 4.33 in.; 25 to 110 mm
Pitch: 0.39 to 11.81 in.; 10 to 303 mm
Cutter type
Width: 0.98 to 4.33 in.; 25 to 110 mm
Pitch: 0.98 to 11.81 in.; 25 to 303 mm
Tear-off type
Width: 0.98 to 4.33 in.; 25 to 110 mm
Pitch: 0.98 to 11.81 in.; 25 to 303 mm
Outer diameter of
paper or Roll size
Maximum ø5.04” (ø128 mm)
Inner diameter of roll core: ø1.5” (ø40 mm)
Model name CG408 DT CG412 TT CG408 TT CG412 TT