To Next PageTo Next Page
Need help?Do you have a question about the SATO RFID and is the answer not in the manual?
General| Print Technology | Thermal Transfer |
|---|---|
| Print Resolution | 203 dpi |
| RFID Standards | EPC Class 1 Gen 2, ISO 18000-6C |
| Connectivity | USB, Ethernet |
| Supported Media Types | Tag |
| Maximum Print Width | 4.09 inches |
Flowchart detailing the menu structure and options available within the RFID Mode for printer configuration.
Displays total accumulated quantity of RFID writes, resettable via Factory Clear.
Displays total accumulated successful RFID writes, resettable via Factory Clear.
Displays total accumulated failed RFID writes, resettable via Factory Clear.
Displays total quantity of RFID writes, sum of successful and failed writes.
Displays total accumulated successful RFID writes.
Displays total accumulated failed RFID writes.
Allows selection to clear RFID write counts using the operator panel.
Selects printer action after write failure: RELEASE deletes job, RETRY attempts until success or error.
Determines the maximum allowed RFID error counts before printer stops.
Allows selection to print a diagonal slash on labels during RFID errors.
Determines command structure for IPO, NEW validates this document's structure, OLD uses previous.
Selects output pattern for RFID errors: PULSE for pulsating, LEVEL for flat.
Determines pulse length for RFID error output, range is 100-500 milliseconds.
Allows selection of the desired RFID module, options are Module A and Module B.
Command sequence for writing EPC code in RFID supply using the NEW command structure.
Command sequence for writing EPC code in RFID supply using the OLD command structure.
Command sequence for reading EPC code information from RFID supply.
