To Next Page
R
rogerslaurenSep 8, 2025
What to do if the cover of my SATO Label Maker is open?
- Mmichael69Sep 9, 2025
If the SATO Label Maker cover is open, ensure that it is closed properly.
What to do if the cover of my SATO Label Maker is open?
If the SATO Label Maker cover is open, ensure that it is closed properly.
What to do if my SATO Label Maker displays a ribbon end error?
If your SATO Label Maker displays a 'Ribbon end' error, it means the ribbon is either out or ripped, or it's not set properly. To fix this, ensure you set the ribbon correctly.
How to fix dim print images on my SATO CG408 Label Maker?
If the SATO Label Maker displays dim print images, adjust the darkness level setting to increase the print head darkness.
What to do if my SATO Label Maker displays a buffer over error?
If your SATO Label Maker shows a 'Buffer over' error, it means the amount of data received exceeds the limit of the receive buffer, or the protocol is wrong. Correct the software on the host side or set the correct protocol to resolve this.
What to do if my SATO CG408 shows a download error?
If your SATO Label Maker shows a download error, it means that you downloaded wrong data. Please, download again.
What to do if the print head of my SATO CG408 is defective?
If the print head of your SATO Label Maker is defective, replace print head as required.
What causes a machine error on my SATO CG408 Label Maker?
If the SATO Label Maker shows a machine error caused by a board defect, board replacement is required.
What to do if the main circuit board of my SATO CG408 is defective?
If the main circuit board of your SATO Label Maker is defective, have SATO authorised servicing personnel replace main board.
How to resolve incorrect label sensor selection on my SATO CG408?
If you have incorrect label sensor selection on your SATO Label Maker, set the sensor correctly by printer setting tool.
What to do if my SATO CG408 displays an incorrect program error?
If the SATO Label Maker has an incorrect program error, it means that the download did not complete successfully. Download again.
Explains symbols used for safety warnings and their meanings.
Detailed steps for loading roll and fan-folded media into the printer.
Instructions for installing carbon ribbon for thermal transfer printing.
Procedures for connecting the printer to a host computer via various interfaces.
How to generate test labels for diagnostic purposes.
Procedure for running factory diagnostic tests on the printer.
How to configure printer settings and select various modes.
Interpreting LED indicators and buzzers for error identification.
Common printer problems and their recommended solutions.
Steps to diagnose and resolve issues with printer interfaces.
Using test prints to identify and resolve print quality issues.
Procedures for cleaning critical printer components for optimal performance.
Instructions for user-replaceable parts like the print head and platen roller.
General| Resolution | 203 dpi |
|---|---|
| Max Print Width | 104 mm |
| Print Method | Thermal Transfer |
| Max Print Speed | 4 inches/sec |
| Media Roll Diameter | 127 mm (5 inches) |
| Memory | 4 MB Flash |
| Interface | USB, Serial, Ethernet |
| Media Sensor | Reflective and Transmissive |
| Media Thickness | 0.06 mm - 0.19 mm |
| Ribbon Length | 100 m (328 ft) |
| Label Thickness Range | 0.06 mm - 0.19 mm |
