Section 7: Interface Specifications
CG4 Series Operator Manual Page 7-11
7.5 LOCAL AREA NETWORK (LAN) ETHERNET
7.5.1 Basic Specifications of LAN
A Local Area Network (LAN) interface requires a driver shipped with each printer that has the interface
installed. The driver must be loaded on the host computer and configured to run one of the supported network
protocols using a 10/100BaseT LAN connection.
Interface connector
Cable type: For 10BASE-T and 100BASE-TX
Cable length: 100m or less
Link/Status LED Status LED lights up when establishing the LINK with Ethernet equipment. The
LINK is established by Auto Negotiation.
LED Color Conditions
LINK Green Lights up when establishing the LINK
SPEED Orange Lights off when recognizing the destination
10BASE-T
Lights up when recognizing the destination
100BASE-TX
COLLISION Red Lights up when collision occurs
Maintenance function [Printing LAN configuration information]
LAN configuration information will be printed on the third sheet of user test print
and factory test print.
[Initializing LAN configuration information]
LAN configuration information will be initialized through [All Clear] of Factory
Clear Mode. For more details, refer to the authorised SATO servicing personnel.
Interface type Use Printer configuration tool or <DI> command.
<DI>a
Parameter Item Value Decription
a Interface
0USB
1LAN
To Next Page
Loading...
Need help?
General
