SATO CG408 User Manual

Section 8: Appendix
CG4 Series Operator Manual Page 8-9
8.6 OFFSET POSITION ADJUSTMENT
This setting adjusts the option (Cutter, Dispenser, Tear off) stop position after a print out.
The Offset position can be adjusted by using SATO Utilities Tool application or by sending command <PO>
from the host. The setting range is within ±99 dots. A positive value moves the leading edge of the label
forward (away from the print head) while a negative value moves the leading edge of the label back toward
the mechanism.
-99 (dot)+99 (dot)
Label feed direction
Stop position for
cutting,dispense
or tear-off
Adjustment for
“+” direction
No
Adjustment
Adjustment for
“-” direction
Adjustment of Offset setting
Base reference
position for printing

SATO CG408 Specifications

General

Resolution	203 dpi
Max Print Width	104 mm
Print Method	Thermal Transfer
Max Print Speed	4 inches/sec
Media Roll Diameter	127 mm (5 inches)
Memory	4 MB Flash
Interface	USB, Serial, Ethernet
Media Sensor	Reflective and Transmissive
Media Thickness	0.06 mm - 0.19 mm
Ribbon Length	100 m (328 ft)
Label Thickness Range	0.06 mm - 0.19 mm