What causes EC SOFTWARE FAIL error on SATO Barcode Reader?
The SATO Barcode Reader displays 'EC SOFTWARE FAIL' due to engine control software failure. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative.
What does B11 ERROR: RAM TEST FAILED mean on SATO Barcode Reader?
The SATO Barcode Reader displays 'B11 ERROR: RAM TEST FAILED' because the printer found a defactive memory location. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative.
What does FILE SYS WRITE Check Flash mean on SATO GL412e Barcode Reader?
The SATO Barcode Reader shows 'FILE SYS WRITE' because there is a problem writing to flash memory. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative.
What does DOWNLOADER ERROR BEYOND 32MB EFC Repeat Download mean on SATO GL412e Barcode Reader?
The SATO Barcode Reader displays 'DOWNLOADER ERROR BEYOND 32MB EFC' because the printer contains an 32MB EFC and the firmware attempted to access beyond its limit. Contact an authorized service representative.
What causes SERIAL PARITY ERROR on SATO GL412e?
The SATO Barcode Reader displays a SERIAL PARITY ERROR due to a parity error (serial interface). Ensure the printer’s serial interface parameter settings match those of the host. Change as required to match.
How to fix power supply issues on SATO GL412e?
Ensure cable properly connected. Check/replace power supply.
Why does my SATO GL412e show ERROR: INSUFFICIENT DRAM Cycle Power?
The SATO Barcode Reader displays 'ERROR: INSUFFICIENT DRAM' because not enough RAM memory is available for the printer to function. Power off the printer for 15 seconds, then power on again. If the message reappears, increase the Glob Mem Adjust size in the PRINTER SETUP menu and reboot the printer. If the message reappears, replace the main circuit board. Write down the message and return it with the defective board.
What should I do if my SATO GL412e displays PRINTHEAD POWER FAIL Cal For Service?
The SATO Barcode Reader shows 'PRINTHEAD POWER FAIL' because the print head lost power. Replace the print head. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative.
What does PRINTHEAD HOT Wait 5 Minutes Go Online mean on SATO GL412e?
The SATO Barcode Reader displays 'PRINTHEAD HOT' because the print head has become overheated. Allow the print head to cool down for 5 minutes, then press the Pause key to resume printing. If possible, reduce print intensity. If the problem persists, contact an authorized customer service representative.
How to fix RIBBON OUT Load Ribbon error on SATO GL412e?
The SATO Barcode Reader indicates RIBBON OUT when the ribbon is broken between the ribbon rewind spindle and the print head or the ribbon supply is empty. To fix this, reattach the ribbon or load the printer with a new ribbon.
General| Brand | SATO |
|---|---|
| Model | GL412e |
| Category | Barcode Reader |
| Language | English |
To Next Page
