KDB-GOM
Series
- 87 -
No 9 Part name Heating strainer
Replacement steps
Disassembly
①
Unplug the boiler from the electric outlet.
②
Open the front cover.
③
Release the heating water inside the boiler by unscrewing the drain screw below the circulator pump.
④
Separate the strainer by separating the
ㄷ
shaped lock.
⑤
Separate the hot water heat exchanger from the strainer by removing the connecting clip.
⑥
Separate the expansion tank from the strainer by removing the connecting connection.
Assembly
①
Fix the strainer to the boiler.
②
Fix the hot water heat exchanger by inserting the connecting clip.
③
Fix the expansion tank and the strainer by inserting the connecting connection.
④
Fix the strainer by screwing the 3 screws under the front cover (check the packing status between the strainer
and return inlet connection).
⑤
Fix the strainer and the
ㄷ
shaped lock.
⑥
Screw the drain screw under the circulator pump.
⑦
Unplug the power cord and after water replenishment, check for water leak
⑧
If everything is fine, close the front cover.
⑨
Plug the boiler into the electric outlet.
Caution
Check for water leak after assembly.
To Next Page
Loading...