KDB-GOM
Series
- 88 -
No 10 Part name Ignition transformer
Replacement steps
Disassembly
①
Unplug the boiler from the electric outlet.
②
Open the front cover.
③
Separate the two high voltage cables of the ignition transformer connected to the electrode from the electrode.
④
Separate the ignition transformer power cord jack.
⑤
Separate the ignition transformer by unscrewing the two screws.
Assembly
①
Screw the two screws fixing the ignition transformer.
②
Connect the ignition transformer power cord jack.
③
Connect the ignition transformer’s two high voltage cords to the electrode.
④
Close the boiler’s front cover.
⑤
Plug the boiler into the electric outlet.
Caution
1. Make sure fixation is done correctly.
2. Check the connection of the connection jack.
⑤
To Next Page
Loading...