Sauder Carson Forge 416969 - Step 14: Attach Backs; Fasten backs using nails; Caution: Do not stand unit upright without back

Step Step 14
å
Lay the BACKS (M and N) over the assembled units.
å
NOTE: The BACK (N) has an unfi nished surface. This BACK
should be placed on the DRAWER ENDS (C and D) with the
unfi nished surface toward the inside of the unit.
å
Make equal marins alon all four edes of the BACKS (M
and N). Push on opposite corners of your units if needed to
make them "square".
å
Fasten the BACKS (M and N) to the units usin the NAILS (1N).
å
NOTE: Perforations have been provided for access throuh the
BACKS. Carefully cut out the holes needed.
Do not stand the unit upriht without the
BACK fastened. The unit may collapse.
Caution
NAIL
(38 used in this step)
1N
C
D
A
B
N
M
Finished
surface
Ede without holes
Ede without holes
416969www.sauder.com/services
Pae 19