Sauder Carson Forge 416969 - Step 24: Attach Door and Door Stop; Fasten door (O) to door left end (B) and insert door stop

Step
416969www.sauder.com/services
Pae 29
Step 24
å
Before fastenin the DOOR to your unit, be sure the
mountin screw is aainst the stops as shown in the riht
diaram. If it isn't, loosen the mountin screw to slide it
aainst the stops. Then tihten the mountin screw.
å
Fasten the DOOR (O) to the DOOR LEFT END (B). Use the
screws in the HINGES. You should start each SCREW a
few turns before completely tihtenin any of them.
å
See the next step for DOOR adjustments.
å
Fasten a KNOB SET (52K) to the DOOR (O). Use a
BLACK 1-1/8" MACHINE SCREW (21S).
å
Insert the DOOR STOP (4I) into the hole in the TOP (H).
Mountin
screw
Stop
Hine
O
4I
B
H
52K
BLACK 1-1/8" MACHINE SCREW
(1 used for the KNOB SET)
21S