EasyManuals Logo

sauter FC 10 User Manual

sauter FC 10
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6 FC-BA-e-1410
Choose the adapter
In order to complete the test work convenient, the standard force gauge is equipped
with a variety of measuring heads. According to the actual need, please select the
appropriate measurement adapter, shown in Fig 2-1:
2.2 Testing
After completing the test preparation, testing can be performed.
How to mount the measuring adapter: Install the adapter in the gauge's
measurement shaft. Tighten it by hand, not by any tools.
NOTE: Do not use tools for tighten the adapter; otherwise it will damage the
force gauge.
Select the appropriate units. A variety of measurement units can be chosen.
In the measure interface, press the Menu key to enter the menu interface, press
or select Measurement, press to enter, and then select Unit to enter.
Choose the unit you desired here.
Select the appropriate Test Mode.
This series has 3 kinds of test modes; select your appropriate test mode for meas-
urement.
Under the measure interface, just press can change the Test Modes one to an-
other.
You can also set it in Menu, see § 3.2.
Track: The real time measuring mode. Under this mode, press the zero key and
you can remove the tare force.
Peak: In Peak mode, the maximum of force will be measured and displayed. Under
this mode, press and the force gauge will update the display immediately.
Flat Conical Chisel Notched Hook
Extension rod Fig 2-1
Fig 2-2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the sauter FC 10 and is the answer not in the manual?

sauter FC 10 Specifications

General IconGeneral
Brandsauter
ModelFC 10
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals