FC-BA-e-1410 7
Preset: In this mode, you can set the tolerance upper limit and lower limit of meas-
ured force value to do a GO/NG measurement. See chapter 3.2.
④ Before measurement, you should zero the tare by pressing .
⑤ The force gauge often is used hand-held. But mounting it on a test stand for use
may be more accurate and easier or safer. We just recommend this way of use.
2.3 Save the measured value
Measured results can be stored in the force gauge; you can review or print them
later.
During the measurement, press the key to store a value, and the storage Icon
will be displayed.
The data stored is the one displayed currently. So, in Track and Preset mode it is the
current force value measured, in Peak mode it is the peak value.
2.4 Browse and print data
All data stored in the memory can be browsed or printed by the mini-printer.
See chapter 3.3.1 and 3.3.2 for details.
3 Setup
3.1 Setup menu
This series force gauge has multi-level menu interface. Show as Table 3-1.
The setting will be very simple:
Under measure interface: Press Menu
key can enter Menu setup.
Under menu interface: Press or can select the item of menu.
Press will confirm a setup and return.
Press can cancel some setting and return or just for return.
To Next Page
Loading...
Need help?
General
