SawStop JSS - Safety Precautions; System Reliance Warning; Bypass Mode Safety; Blade and Dado Set Guidelines

For Your Safety
Do Not operate the saw in bypass mode unless necessary to cut conducve materials. The safety system will
not acvate while in bypass and you could be seriously injured if you contact the spinning blade.
OFF
SLOW
Bypass
Only use a single standard 10” table saw blade or an 8” dado set up to 13/16” wide. Non-standard blades,
including unusually thin or thick blades, may cause serious injury to you and may damage your saw. Also,
the motor will not start unless a 10” blade or 8” dado set with oponal dado brake cartridge is installed.
Never use a blade with damaged or missing teeth. Never install a blade backwards.
10 “ Blade
8” Dado
Do Not rely on the SawStop safety system to protect against carelessness or inaenon. The safety system
minimizes the severity of an injury due to blade contact, but you must contact the blade to acvate the
system, and it is possible to be seriously injured on a SawStop saw if you contact the blade at a higher than
normal speed.
23
www.sawstop.com
Both the riving knife and the blade guard spreader are designed for 10” blades and have a thickness of
2.3mm. Only use 10” blades with a kerf between 2.35mm and 3.5mm, and with a blade body between
1.8mm and 2.1mm.