Page 7
2 Safety Instructions
• Read this instruction manual before using the portable density meter SBS-3500.
• Follow all hints and instructions contained in this instruction manual to ensure the correct use
and safe functioning of the SBS-3500.
Liability
• This instruction manual does not claim to address all safety issues associated with the use of the
instrument and samples. It is your responsibility to establish health and safety practices and
determine the applicability of regulatory limitations.
• SBS only warrants the proper functioning of the SBS-3500 if no adjustments have been made to
the mechanics, electronics, and firmware.
• Only use the SBS-3500 for the purpose described in this instruction manual. SBS is not liable for
damages caused by incorrect use of the SBS-3500.
Installation and Use
• The SBS-3500 is not an explosion-proof instrument and therefore must not be operated in areas
with risk of explosion.
• Never remove the pump lock and battery cover in hazardous areas. Only exchange the batteries
outside of hazardous areas.
• The installation procedure shall only be carried out by authorized personnel who are familiar
with installation instructions.
• Do not use any accessories or wearing parts other than those supplied or approved by SBS.
• Make sure all operators are trained to use the instrument safely and correctly before starting
any applicable operations.
• In case of damage or malfunction, do not continue operating the SBS-3500. Do not operate the
instrument under conditions which could result in damage to goods and/or injuries and loss of
life.
• Check the SBS-3500 for chemical resistance to the samples and cleaning liquids.
• Do not expose the instrument to temperatures below 0ºC (32ºF) if water is contained in the
measuring cell or pump (freezing water will cause rupture of the measuring cell).
Maintenance and Service
• The results delivered by the SBS-3500 not only depend on the correct functioning of the
instrument, but also on various other factors. We therefore recommend you have the results
checked (e.g. plausibility tested) by skilled personnel before consequential actions are taken
based on the results.
• Service and repair procedures may only be carried out by authorized personnel or by SBS.
To Next Page
Loading...