Scaime IPE 50 Series - Power Supply and Electronic Card; 24 Vdc Power Supply Details; Jumper Configuration; Serial Port Settings

12
POWER SUPPLY 24 Vdc
1 +24Vdc + 12 to 25Vdc / 3.6 W max
2 GND - 0 Vdc
Sensor : attention, the power supply of the sensors (5Vdc) and the maximum power is 120mA for example 8 sensors 350 Ohm
connected.
Channel 1 for sensor 4 or 6 wires
+ SIG + SIGNAL
- SIG - SIGNAL
+ SEN + SENSE
- SEN - SENSE
+ EXC + EXCITATION
- EXC - EXCITATION
For a 4 wires sensor, please make 2 jumpers between +EXC and +SEN, -EXC and -SEN
Electronic card of the IPE50Panel
Connector BOOT : to install option card timer or alibi memory
(DSD)
Jumper CAL opened: trade-approved mode
3 jumpers to select on COM1 RS232 or 485
3 jumpers between pins 1 and 2 -> RS485
3 jumpers between pins 2 and 3 -> RS232
Serial port COM1
RS485 or RS232
A + TX
B - RX
GND
Serial port COM2 RS232
TX 2
RX 2
GND
RS485
RS232