Need help?Do you have a question about the Scania DC13 076 and is the answer not in the manual?
Warning about the risk of injury when working on the engine.
Summary of safety precautions for operating and inspecting Scania engines.
Prohibition of smoking in hazardous areas.
Precautions before starting and during engine operation.
Warning about using the correct fuel grade.
Warning about toxic exhaust gases.
Flammability of fuels and lubricants and handling precautions.
Warnings and first aid for reductant (AdBlue/DEF).
Steps to ensure the engine is safely shut down.
Warning about burns from hot engine parts and fluids.
Hazards associated with batteries and charging.
Safety procedures for working on the electrical system.
Warnings about hot oil and pressure in the lubrication system.
Warning about opening the coolant filler cap when hot.
Warning about high-pressure fuel escaping.
Specific warranty for emission control systems.
General terms and conditions of the warranty.
Duration and scope of the manufacturer's warranty.
Warning about vanadium pentoxide in the SCR catalytic converter.
Safety measures when working with the SCR system.
First aid for SCR dust exposure (inhalation, eyes, skin, ingestion).
Pre-run checks including fluid levels and belt condition.
Warning about running the engine without reductant.
Procedures for starting the engine, including fuel feed.
Warning against using starter gas.
System warnings for SCR system faults or low reductant.
How the engine reacts to low reductant levels.
Engine response to faults in the SCR system.
Normal operating coolant temperature and alarm levels.
Normal oil pressure and alarm levels.
Risk of post-boiling and damage if engine is shut off without cooling.
Warning about hot water and protective equipment.
Explanation of Scania LDF and recommended oils.
Quality requirements for engine oil.
Procedure for checking engine oil level.
Procedure for changing engine oil and replacing the oil filter.
Warnings about hot oil and lubrication system pressure.
Procedure for cleaning the centrifugal oil cleaner.
Warning about hot oil when cleaning the oil cleaner.
Steps for cleaning the rotor and its parts.
Steps for fitting new inserts and O-rings, and tightening.
Final steps for refitting and securing the rotor shaft.
Procedure for renewing the engine oil filter.
Properties and importance of coolant.
Warning about the toxicity of ethylene glycol.
Coolant properties and protection against freezing.
Chart showing coolant properties vs. antifreeze concentration.
Table for calculating antifreeze concentration based on volume.
Table for calculating antifreeze concentration in US gallons.
Procedure for checking the coolant level.
Warning about opening hot coolant filler cap.
Advice on topping up coolant and avoiding cracks.
Method for checking coolant antifreeze and inhibitor content.
Rules for antifreeze/corrosion inhibitor content.
Procedure for changing the engine coolant.
Procedure for filling the cooling system with coolant.
Pumping coolant from underneath to avoid air pockets.
Caution against using alkaline detergents on aluminium.
Procedure for renewing the air cleaner filter element.
Warning against starting the engine without the air filter.
Procedure for renewing the air cleaner safety cartridge.
Emphasis on cleanliness when working on the XPI fuel system.
Procedure for checking and topping up fuel level.
To Next Page
General
