OPM 200 en-GB 33
©
Scania CV AB 2014, Sweden
Lubrication system
Changing the oil
Renew the oil filter and clean the centrifugal oil
cleaner when changing oil.
• Hot oil can cause burns and skin irritation.
Wear protective gloves and goggles when
changing hot oil.
• Make sure that there is no pressure in the lu-
brication system before starting work on it.
• The oil filler cap must always be in place
when starting and running the engine to pre-
vent oil being ejected.
Use a container to avoid spillage. Used oil must
be disposed of as specified in national and inter-
national law.
Change oil more often if the engine is subjected
to particularly demanding operation, such as a
dusty environment, or if deposits in the centrifu-
gal oil cleaner are thicker than 28 mm (1.1 in).
1.
Unscrew the oil plug and drain the oil when
the engine is hot.
In certain engines the oil is pumped out by
means of a bilge pump.
2.
Clean the magnet on the oil plug.
3.
Refit the oil plug.
4.
Top up with oil.
5.
Check the level on the oil dipstick.
314 603
Max. 45 litres (11.9 US gallons)
Min. 39 litres (10.3 US gallons)
314 602
Max. 34 litres (9 US gallons)
Min. 28 litres (7.4 US gallons)
Property of American Airlines
To Next Page
Loading...
Need help?
General
