OPM 200 en-GB 4
©
Scania CV AB 2014, Sweden
Introduction
Introduction
This Operator's Manual describes the operation
and inspection of Scania industrial engines.
The engines are direct-injection, liquid-cooled,
four-stroke, turbocharged diesel engines. Certain
engines are also equipped with an SCR system
for emission control.
The engines are available with different output
and engine speed settings. The normal output
setting of the engine (performance code) is indi-
cated on the engine data plate.
Only standard components are described in the
operator's manual. Information about special
equipment is contained in instructions from the
various manufacturers.
To ensure the maximum performance and the
longest service life for the engine remember the
following:
• Read through the Operator's Manual before
starting to use the engine. Even regular users
of Scania engines will get new information
from the Operator's Manual.
• Always follow the inspection instructions.
• Read the section on safety carefully.
• Get to know your engine so that you know
what it can do and how it works.
• Always contact a workshop with qualified
personnel for inspection and repair.
The information in this manual was correct at the
time of going to press. Scania reserves the right
to make alterations without prior notice.
Property of American Airlines
To Next Page
Loading...
Need help?
General
