Scania DI16 - Inspection Schedule Details; Maintenance Schedule Summary

© Scania CV 2011 25
Inspection schedule
1. More often if required.
2. For engines with few operating hours, see page 24.
3. Earlier if the vacuum indicator shows red.
4. Only applies to marine engines with sea water pump and heat exchanger.
5. Guideline value. Varies depending on the composition of the sea water.
6. If inhibitor has not been topped up for 5 years, the coolant should be changed.
Daily
First
time at
Interval At least
First start 400 h 200 h 400 h 1,200 h 2,400 h 4,800 h Annually Every 5 years
Lubrication system, page 26
1. Checking the oil level

2. Oil change
1 
3. Cleaning the centrifugal oil cleaner
1 
4. Renewing the oil filter and closed crankcase ventilation
filter
1 
Cooling system, page 31
5. Checking coolant level

6. Checking sacrificial anodes 4)
5 
7. Checking the sea water pump impeller 4)
5 
8. Checking the coolant
6 6
9. Cleaning the cooling system
1 
Air cleaner, page 40
10. Checking the read-out from the vacuum indicator

11. Cleaning or renewing the filter element
3 
Fuel system, page 42
12. Checking fuel level

13. Renewing the main filter and water separating filter
1 
Electrical system, page 44
14. Checking the electrolyte level in batteries
2 
15. Checking the state of charge in batteries
2 
16. Cleaning batteries
2 
17. Checking the coolant level monitor

Miscellaneous, page 46
18. Checking the drive belt

19. Check for leaks, rectify as necessary

20. Checking and adjusting the valve clearance

21. Checking and adjusting PDE injector rocker arms
