SCANMASKIN 18 - Safety Regulations; Safety precautions

Scanmaskin 18 – Manual
Chapter 1
- 42 -
1.6 Overview Scanmaskin 18
Figure 1-2 Scanmaskin 18 overview
Item
Description
Reference / Article no.
1
Handle
520147
2
Control device
520082 4.3 Control devic
3
Frame
520131
4
Motor control
4.6 Control panel
5
Electrical cabinet
520172
6
Lower frame
520149
7
Power plug chassis
520156 + 570153
8
Power plug motor
520157 + 570152
9
Wheel
520087
10
Clamp
520136
11
Hose holder
520146
12
Motor
520078
13
Lifting handle
3.3 Lifting
14
Sprint
520145
15
Machine house cover
520140
16
Dust cover
520011
17
Wheel lock
520160
Table 1-3 Machine parts overview
Scanmaskin 18 – Manual
Chapter 2
- 43 -
2 Safety Regulations
Read this entire chapter carefully! Failure to comply with safety regulations may result in
serious injuries or damages.
2.1 Legend
Notation regarding safety
Notation regarding electrical safety
Notation regarding safety during transport
Tipping hazard
See reference
2.2 Safety precautions
Any machine, if it is not used according the regulations, may be hazardous for operating,
setting-up and service personnel. The operating authority is responsible
for compliance with
the safety regulations during operation and maintenance, and for the use of safety devices
supplied with the machine, as well as the provision of appropriate additional safety devices!
Eye and ear protection must be worn at all times.
Never operate the machine when it’s not in its upright position.
Make sure there is no debris in the work area.
Check the work area for screws or other hard objects in the concrete. Don’t use the machine
if there are any foreign objects stuck into the surface. Such objects must be removed prior to
operation of machine.
Read “2.3 Organizational measures” and “2.5 Safety regarding operation of machine”
thoroughly before operation!
42 43
ENGLISH
SCANMASKIN 18
www.scanmaskin.com www.scanmaskin.com