2.3 Organizational measures
The user guide is to be kept near the location where the machine is being operated and must
be within reach at all times.
In addition to this user guide general and legal regulations regarding accident prevention and
environmental protection must be complied with as per local regulations.
Such duties may, for example, relate to the handling of hazardous substances, or to the
provision and wearing of personal protection equipment, as well as compliance with traffic
regulations.
The user guide must be supplemented by other instructions, including the duty to supervise
and report incidents relating to particular working practices, for example work organization,
work procedures and personnel safety.
Personnel entrusted with working with the machine must read the User Guide before starting
work, in particular the “2 Safety Regulations” chapter. To read these instructions after work
is commenced is too late. This particularly applies to incidental activities such as setting up
the equipment, carrying out maintenance work or training staff to work with the machine.
From time to time the working practices of the operators are to be checked by a supervisor
especially to the items regarding awareness of safety and hazards.
Operators must tie back long hair, and not wear loose clothing or jewelry including rings.
There is a risk of injury through items getting caught, or being drawn into moving
machinery.
Eye and ear protection must be worn at all times!
Use personnel protection equipment if necessary or required by local regulations! Take
notice of all safety and hazard notices on the machine!
All safety and hazard notices at or on the machine must be kept complete and legible!
If safety-critical changes occur to the machine or its working method, the machine must be
shut down immediately! The cause of the fault must be established, and rectified.
Changes, add-ons or conversation to the machine, which might impair safety, must not be
made, without the manufacturer’s permission!
This applies in particular to the fitting and adjustment of safety devices.
Spare parts must comply with the technical requirements specified by the manufacturer. This
is always guaranteed if original spare parts are used.
Intervals for recurring checks and inspections specified in this User Guide must be complied
with!
To perform maintenance work correctly it is imperative to be equipped with the proper tools
for the task in question.
Repairs may only be made by Scanmaskin Sweden AB certified service technicians.
Some grinding work may generate sparks under certain circumstances. Personnel working
with the machine must therefore be aware of the risk of fire and how to handle a fire
situation properly.
Do not use the machine in areas with highly flammable and/or explosive materials.
2.4 Personnel selection and qualification
Fundamental duties:
• Work with the machine may only be undertaken by trained personnel.
• Specify clearly the respons
ibilities of personnel for operation, setting up, servicing and
maintenance work!
• Make sure that only authorized personnel operate or work with the machine!
•
Define responsibilities of the machine operator, with regard to traffic safety regulations, and
inform him not to take instructions from third parties who may not be complying with the local
safety requirements.
• Personnel, who are being trained to operate equipment, may only use the machine under
constant supervision of an experienced person!
• Work on electrical equipment may only be undertaken by a skilled electrician or by trained
persons under the supervision of a skilled electrician, as well as in accordance with the local
electrical engineering regulations.
2.5 Safety regarding operation of machine
Do not allow any method of working that impairs safety!
Recognized official procedures have to be used to ensure the machine is operated in safe
and best conditions.
Only operate the machine when all safety devices and related safety equipment are present
and operational!
Check the machine visually for any damage and defects at least once a day.
In the event of operational malfunctions the machine must be shut down immediately and
secured!
44 45
ENGLISH
SCANMASKIN 18
www.scanmaskin.com www.scanmaskin.com
To Next Page
