Why is there picture but no audio on my Sceptre TV?
If you see a picture but hear no sound on your Sceptre TV, first, check that the audio cable is securely connected. Next, readjust the volume using the remote control. Also, the TV’s tuner signal must not be lower than 65 %.
What to do if my Sceptre TV remote control does not work?
If your Sceptre TV remote isn't working, try these steps: Turn off the TV, unplug it, and remove the batteries from the remote for 30 seconds. Press the remote buttons and the power button randomly for 2 seconds, then reinstall the batteries. Also, ensure there's a clear line of sight between the remote's front sensor and the TV's remote sensor, which is located near the power indicator light.
What to do if there is audio but no picture on my Sceptre TV?
If you are getting audio but no picture on your Sceptre TV, ensure that both your video and audio cables are properly connected. Also, the TV’s tuner signal must not be lower than 65 %.
How to get more channels on my Sceptre TV?
If your Sceptre TV isn't receiving enough channels through the ATSC/NTSC tuner, change the direction of your antenna and rescan for channels. If you have cable, contact your cable company to inquire about the signal strength of your local cable.
What to do if Sceptre TV says no HDCP support?
If your Sceptre TV displays 'no HDCP support', reboot your HDCP video device by turning it off and unplugging the power cord. Wait up to 8 minutes before plugging the power back in.
How to unblock channels on Sceptre TV?
If channels are blocked on your Sceptre TV, check the auto lock function’s settings within the OSD. You may have inadvertently locked some channels.
What is the universal remote code for Sceptre TV?
This Sceptre TV follows SONY’s universal remote code. Please check your handbook for SONY’s codes then apply them.
How to fix unclear and unstable display on Sceptre monitor?
To stabilize and clarify the display on your Sceptre monitor, use the AUTO ADJUST function. Alternatively, set the resolution to the optimal setting of 1920 X 1080 at 60Hz, and then use AUTO ADJUST.
Why I do not hear any sound from the speakers of my Sceptre E24?
If you're not hearing sound from your Sceptre monitor's speakers, first check the 3.5 mm mini-jack cable connection between your computer and the monitor. Then, verify the volume levels on both your computer and the monitor itself.
How do I reset my Sceptre E24?
To reset your Sceptre monitor, ensure there's a valid video signal, then press the menu button to open the OSD. Look for the ALL RESET option under the MISC. options.
General| Screen Size | 24 inches |
|---|---|
| Refresh Rate | 75Hz |
| Response Time | 5ms |
| Brightness | 250 cd/m² |
| Ports | HDMI, VGA |
| Aspect Ratio | 16:9 |
| Resolution | 1920 x 1080 |
| Resolution Type | FHD |
| Viewing Angle | 178° (H) / 178° (V) |
| VESA Mount Compatible | Yes (75 x 75mm) |
To Next Page
