Why under MHL the display’s remote won’t control the cell phone screen fully on my Sceptre Monitor?
When using MHL, the display’s remote won’t fully control the cell phone screen on your Sceptre Monitor. For total control, use the cell phone’s touch screen. The display’s remote has limited functions dependent on the program you are using.
Why is there no audio on my Sceptre X328BV-SR Monitor, but I can see the picture?
If you see a picture but hear no audio on your Sceptre Monitor, first ensure the audio cable is properly connected. Also, readjust the volume using the remote control. If you are using a TV tuner, the signal must be at least 65%.
Why is there audio only, but no picture on my Sceptre Monitor?
If your Sceptre Monitor is producing audio but no picture, ensure that both your video and audio cables are connected. If you're using a TV tuner, make sure the signal strength is at least 65%.
Why is there no sound on my Sceptre X328BV-SR Monitor when connected to a PC?
If there's no sound on your Sceptre Monitor when connected to a PC, ensure you have a 3.5 mm mini-jack cable connected from your PC’s sound output to the display’s VGA STEREO INPUT.
Why is there no audio with HDCP video on my Sceptre X328BV-SR Monitor?
If there's no audio with HDCP video on your Sceptre Monitor, ensure a 3.5 mm mini-jack cable is connected from your HDCP video device’s sound output to the display’s VGA STEREO INPUT. If your HDCP video device uses RCA AUDIO jacks, you’ll need an RCA audio converter to a 3.5 mm mini-jack cable.
Why does switching a channel or source change the volume on my Sceptre Monitor?
Switching channels or sources may change the volume on your Sceptre Monitor because different channels and inputs have varying signal volumes. The display has an AUTO VOLUME LEVEL function that can help mitigate this effect; ensure this function is turned on.
What is the universal remote code for Sceptre X328BV-SR Monitor?
The Sceptre Monitor follows SONY’s universal remote code. Check your handbook for SONY’s codes and apply them.
What to do if my Sceptre X328BV-SR Monitor HDCP video says no HDCP support?
If your Sceptre Monitor's HDCP video displays a 'no HDCP support' message, reboot your HDCP video device by turning it off and unplugging the power cord. Wait up to 8 minutes before plugging it back in.
How do I get rid of the big black box in the middle of my Sceptre X328BV-SR screen?
The big black box in the middle of the Sceptre Monitor screen indicates that closed captioning is turned on and set to TEXT1 – TEXT4. Change the setting to CC1 or turn off closed captioning to remove the box.
Why does my Sceptre Monitor have no color?
If your Sceptre Monitor displays no color, adjust your picture settings and ensure that the saturation and RGB settings are not turned all the way down. Also, if you are using a TV tuner, check your signal strength to ensure it is adequate.
General| Screen Size | 32 inches |
|---|---|
| Panel Type | LED |
| Refresh Rate | 60 Hz |
| Aspect Ratio | 16:9 |
| Brightness | 250 cd/m² |
| Contrast Ratio | 3000:1 |
| Response Time | 5 ms |
| Built-in Speakers | Yes |
| HDMI Ports | 1 |
| Ports | HDMI, VGA |
| Viewing Angle | 178° horizontal, 178° vertical |
| VESA Mount Compatible | Yes |
| Resolution | 1920 x 1080 (Full HD) |
To Next Page
