Schaeffler YRTC - Table of Contents

Schaeffler Technologies MON 100 1
Page
High precision bearings for combined loads
About the mounting manual Symbols ................................................................................... 2
General safety guidelines Usage for the intended purpose ................................................ 2
Qualified personnel .................................................................. 2
Safety guidelines ...................................................................... 3
Preparations for fitting Bearings with magneto-resistive angular measuring system....... 5
Bearings with inductive angular measuring system.................... 7
Delivered condition of the bearings ........................................... 8
Initial greasing.......................................................................... 8
Bearing storage and storage life ................................................ 8
Compatibility and miscibility with anti-corrosion agents ............ 9
Cleaning of bearings ................................................................. 9
Removing bearings from packaging ........................................... 10
Transport of bearings ................................................................ 10
Design of fitting area................................................................. 12
Protection measures during fitting............................................. 13
Preparation of the adjacent construction ................................... 13
Selection of fasteners ............................................................... 14
Checking the tolerances of the screw mounting surfaces ........... 14
Fitting Checking the dimensional and
running accuracy of the bearings............................................... 15
Locating the bearing rings......................................................... 15
Function and safety checks Checking the bearing frictional torque....................................... 19
Checking running accuracy........................................................ 19
Checking the fixing screws ........................................................ 20
Lubrication ................................................................................................ 21
Relubrication of bearings .......................................................... 22
Overlubrication......................................................................... 25
Initial operation ........................................................................ 25
Further information Publication requests ................................................................. 26