Schaeffler Technologies
MON 100
3
Safety guidelines
Ensure correct handling during the individual phases:
■
opening the packaging
■
transporting the bearing
■
mounting the bearing
■
screw mounting the bearing rings
Transport and storage
Protect bearings from exposure to load resulting from incorrect
transport or storage. Large bearings should only be stored lying flat
and should be transported lying flat if possible.
Unpacking, transport, packing and storage may only be performed by
appropriately qualified personnel.
Mounting
Before and during fitting, the bearings and measuring system
must be handled with care and in accordance with this fitting and
maintenance manual.
Bearings should only be fitted using the tools and fitting aids
specified. If unsuitable or contaminated tools and fitting aids are
used, this will seriously impair the function of the bearings and
significantly reduce their operating life.
Mounting, regreasing, the grease distribution cycle and
commissioning may only be performed by appropriately qualified
personnel.
Adjacent construction
The sequence of operations depends on the design of the adjacent
construction. It is therefore not possible to provide a single descrip-
tion that includes all the fitting variants.
Since, in the majority of applications, the bearing inner ring is fitted
on the shaft first and the bearing outer ring is then fixed in place,
the fitting of the bearings is described on the basis of this fitting
process.
If the adjacent construction is different, fit the bearing appropriately
or contact us for advice.
To Next Page
Loading...
