Schaerer Ambiente - Page 13

11
One of the beverage buttons on the control panel is
stuck. Its green led should be on. Press a few times to
see if it releases. If message persists, call for service.
The machine is registering a disruption in the control
function of the motor to the brew group. Turn the
machine off and back on again. Press the single
espresso button. If the message disappears, it was
temporary (i.e. voltage drop). If message persists, call
for service.
The machine is registering a failure in the control
function of the motor to the brew group (see motor
control). Turn machine off and on again. Make an
espresso. If message persists, call for service.
The machine is registering a failure in the temperature
probe of the hot water (coffee) boiler. Turn the machine
off and back on again. If message persists, call for
service.
The machine is registering a failure in the temperature
probe of the steam boiler. Turn the machine off and
back on again. If message persists, call for service.
The machine is registering a failure in the refill program
of the steam boiler. Make sure that the main water valve
to the machine is open. Turn the machine off and back
on again. If message persists, please call for service.
The machine is registering a failure in the temperature
sensor of the steam wand. Please call for service.
The machine is registering a shortage or overage in
power supply to its main computer board. Turn the
machine off (to standby) and back on again. If message
persists, call for service.
The machine registers a memory failure in either the
Ram or the E-prom chip. This is usually caused by a
power surge or a loose chip. Call for service.
The machine registers a memory failure in either the
Ram or the E-prom chip. This is usually caused by a
power surge or a loose chip. Call for service.
The battery of the main PC board in the machine is low
and needs to be replaced. Call for service.
The machine is registering an interruption in the water
flow to and/or through the machine. Press the hot water
button. If this doesn’t work, make sure that the main
water valve or any inline filters to the machine are all
unobstructed. If message still persists, call for service.
<<Button?>>
selection Locked
select beverage
motor control
select beverage
motor time-out
select beverage
flowmeter defect
select beverage
temp probe coffee
select beverage
level probe steam
select beverage
out let sensor brok.
selection locked
power fail
system data error
press stop key
product data error
press stop key
replace battery
select beverage
temp probe steam