EasyManua.ls Logo

Schaudt Electroblock EBL 30 - Closing Down the System

Schaudt Electroblock EBL 30
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Instruction Manual for Electroblock EBL 30 / EBL 30 with OVP
6
Date: 15.10.2018 8110305 BA / EN
Fault RemedyPossible cause
12V supply does not work
i
n
t
h
e
l
e
i
s
u
r
e
a
r
e
a
12V main switch for the li-
v
i
n
g
a
r
e
a
b
a
t
t
e
r
y
i
s
s
i
t
12V main switch for the li-
v
i
n
g
a
r
e
a
b
a
t
t
e
r
y
m
u
s
t
b
e
i
nt
h
e
l
e
i
sure area v
i
ng area
b
attery
i
ssw
i
t-
ched off
v
i
ng area
b
attery must
b
e
switched on
Not all plugs/fuses are
p
l
u
g
g
e
d
i
n
t
o
t
h
e
e
l
e
c
t
r
o
Pug all plugs and fuses
(
c
o
r
r
e
c
t
r
a
t
i
n
g
s
)
i
n
t
o
t
h
e
p
l
ugge
d
i
nto t
h
ee
l
ectro-
block
(
correct rat
i
ngs
)
i
nto t
h
e
electroblock
Defective fuse or cabling Have the fuse and cabling
e
f
e
c
t
i
v
e
f
u
s
e
o
r
c
a
b
l
i
n
g
a
v
e
t
h
e
f
u
s
e
a
n
d
c
a
b
l
i
n
g
checked
Defective electroblock Contact customer service
Y The charging current is reduced automatically if the device becomes too
hot due to excessive ambient temperature or lack of ventilation. Always
prevent the device from overheating nevertheless.
Y If the automatic shutdown mechanism of the battery monitor is triggered,
fully charge the living area battery.
3.4 Closing down the system
The battery is isolated by switching off the battery cut-off switch.
Y ATTENTION!
Total discharge.
Damage to the leisure area battery:
F Fully charge the living area battery before and after closing down the
system. (Connect vehicle to the mains with an 80Ah battery at least
12 hours and with a 160Ah battery at least 24 hours).
Disconnect the living area battery from the 12V power supply if the motor-
home is not used for a longer period (during the winter for example).
" Fully charge the living area battery before closing down the system.
" Switch off the main switch on the IT ... / LT ... control and display panel.
" Move the battery cut-off switch (see Fig. 4, Pos. 12) to the ”Battery OFF”
position. The following connections are isolated from the living area bat-
tery:
F All 12V consumers
F Frost protection valve
F Operator and control panel
The living area battery is then protected against total discharge. This only
applies if the battery is intact. Follow the battery manufacturer’s instructions.
Y If the living area battery is isolated from the electroblock with the battery
cut-off, the frost protection valve of the combination heater opens. A loss
of water is possible (see the operating instructions for the combination
heater).
Closing down

Related product manuals