Schenker WIKI User Manual

5 – STARTING REV.02
EN
THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
19
2 Fill the inlet hose of the watermaker with water in
order to allow the pump to prime.
3 Turn on the watermaker
4 After 1 minute, close the depressurization valve.
The system starts going under pressure and the
fresh water production begins. Check the
working pressure of the unit is correct (6,5 – 7,5
bar).
5.1.3 Turning off the machine
At the end of production (which can be estimated at 30 litres/h), turn off the watermaker using the switch. It is
recommended to turn off the watermaker immediately after the typical “knock” of the machine (just after the
beep).
Disconnect the pipes, empty them of water, disconnect the electrical cable and place the watermaker and
pipes in the appropriate bags.

Schenker WIKI Specifications

General

Brand	Schenker
Model	WIKI
Category	Water Filtration Systems
Language	English