www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
39
The paint pattern is tailing.
The pressure control dial (9) is set too
low.
Increase the pressure control dial (9) to a higher
setting.
clogged.
The suction hose (11) is loose at the
suction hose inlet port (15).
Re-adjust the suction hose (11) to the suction
-
driver to tighten the screw on the metal hose
clamp suction hose inlet port (16).
The spray tip (5) is worn. Replace the spray tip (5).
The paint is too thick.
Thin the paint according to the
manufacturer's instructions.
To Next Page
Loading...