www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
23
Brush edge
The grinding head of this power tool is enclosed by
advantages:
a) The brush edge (1 0) protrudes beyond the grind-
ing plate (9) and touches the surface to be pro-
in parallel to the working area before the insertion
tool comes in contact with the surface which is
to be processed. This is to prevent the formation
of sickle-shaped recesses caused by the grind-
ing disk edge.
b) Furthermore, the brush edge (10) prevents the
generation of excessive dust. Dust generated du
ring the grinding process is not transported to-
wards the outside but is removed by the extrac-
tion system. Make sure before each operation
with this power tool that the brush edge (10) is
not damaged. Have it replaced if there is dam-
age or wear.
Connection to the power supply
1.
before connecting the power tool to the power
supply.
2. Plug the power plug into a correctly installed
socket which complies with the requirements
3. Your power tool is now ready for operation.
8. Operation
Oscillation rate
Before you start working with the swing speed to
match the appliance. Use a low swing speed for
work.
1. Rotate the adjustment wheel (6) to adjust the os-
cillation rate. Turn the wheel clockwise to reduce
2. Turn the wheel counter-clockwise to increase the
Switching on/o
To switch on:
(a)
Note: The insertion tool moves for a short while after
until the insertion tool has come to a complete halt.
Sandpaper
Selection
1.
the coarser the graining.
2. Use sandpaper with coarse grain for rough grind-
We recommend sandpapers with aluminium ox-
ide, silicon carbide or other synthetic abrasives.
3. -
ent graining, you should start with coarse grain-
ing sandpaper and complete the grinding process
good and smooth grinding results.
How to apply and replace sandpaper
Apply the sandpaper (13) to the grinding plate (9) us-
ing the Velcro strip mechanism.
1. Align the sandpaper (13) with the grinding plate
(9) and press it on evenly.
2.
5).
Dust extraction
WARNING! Harmfull noxious gases may be gen-
erated when e.g. lead-containing paint is pro-
cessed. These gases entail a risk for the opera-
tor and the persons in the vicinity!
Therefore only use the power tool in combination
with a dust extraction unit, and protect yourself
and other persons in the working area with ad-
ditional suitable personal protective equipment!
When working with this power tool, a Iot of dust is
generated. The dust extraction unit is very useful if
you want to keep your workplace clean. lt is possi-
ble to combine the extraction system or a vacuum
cleaner with the extraction hose (11) which is con-
nected to the adapter for dust extraction.
1. Align the nose at the hose end with the extraction
2. Connect the dust extraction adapter with a suitable
8).
Note: Make sure that the vacuum cleaner is suitable
for being used together with a power tool.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
