Scheppach HC25Si - Cleaning, Maintenance and Storage; Troubleshooting; Compressor Not Starting; No Pressure Issues

12
12. Disposal and recycling
The device is supplied in packaging to avoid trans-
port damages. This packaging is raw material and
can thus be used again or can be reintegrated into
the raw material cycle.
The device and its accessories are made of di󰀨er-
ent materials, such as metals and plastics. Take de-
fective components to special waste disposal sites.
Check with your specialist dealer or municipal admin-
istration!
13. Troubleshooting
Fault Possible cause Remedy
The compressor
does not start.
Mains voltage is not available. Check the cable, mains plug, fuse and socket.
Mains voltage is too low. Make sure that the extension cable is not too long.
Use an extension cable with large enough wires.
Outside temperature is too low. Never operate with an outside temperature of
below +5 °C.
Motor is overheated. Allow the motor to cool down. If necessary, reme-
dy the cause of the overheating.
The compressor
starts but there is no
pressure.
The safety valve leaks. Contact your local service centre. Only allow qual-
ied personnel to carry out repairs.
The seals are damaged. Check the seals and have any damaged seals
replaced by a service centre.
The drain screw for condensate leaks. Tighten the screw by hand. Check the seal on the
screw and replace if necessary.
The compressor
starts, pressure is
shown on the pres-
sure gauge, but the
tools do not start.
The hose connections have a leak. Check the compressed air hose and tools and
replace if necessary.
A quick coupling has a leak. Contact your local service centre. Only allow qual-
ied personnel to carry out repairs.
Insu󰀩cient pressure set on the pres-
sure regulator.
Increase the set pressure with the pressure regu-
lator.