23GB
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
12. Disposal and recycling
The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
in this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Never
place defective equipment in your household refuse
The equipment should be taken to a suitable collection
center for proper disposal. If you do not know the
whereabouts of such a collection point, you should ask
in your local council ofces.
13. Storage
Store the equipment and accessories out of children’s
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
10. Accessories
10.1. Accessories (Fig. 12)
b Cutting-off wheel
c Grinding roller (large)
d Grinding belt (small)
e Grinding wheel
10.2. Accessories (Fig. 13)
f Molding cutter (trapeze)
g Molding cutter(ball-shaped)
h Molding cutter(cone)
i Metal grinding pin (cylindrical)
j Metal grinding pin (cone)
k Metal grinding pin (ball-shaped)
10.3. Accessories (Fig. 14)
l Grinding pin (nely granulated)
m Grinding pin (cylindrical ne)
n Grinding pin (cone ne)
o Grinding pin (cylindrical nely granulated)
p Grinding pin(very nely granulated)
10.4. Accessories (Fig. 15)
q Grinding pin (truss head, rough)
r Grinding pin(truss head small, rough)
s Grinding pin (cone rough)
t Grinding pin (Round rough)
u Grinding pin (Round small, rough)
v Grinding pin (truss head middle, rough)
10.5. Accessories (Fig. 16)
E Trapezebrush small
F Trapezebrush large
G Roundbrush
H Trapezebrush large brass
I Roundbrush brass
J Trapezebrush small brass
10.6. Accessories (Fig. 17)
K Grinding wheel insertion
L Screw insertion
M Grinding cylinder for grinding roller small
N Grinding cylinder for grinding roller large
10.7. Accessories (Fig. 18)
O Felt polishing cone
P Felt polishing wheel (small)
Q Felt polishing wheel (large)
R Grinding stone
S Polishing paste
10.8. Accessories (Fig. 19)
N Clamping sleeve 2.0-3.2 mm
11. Replacing the power cable
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
To Next Page
Loading...
Need help?
General
