www.scheppach.com
30
|
GB
17. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool
fails to work properly. If the problem persists after working through the list, please contact your nearest service
workshop.
Problem Possible Cause Remedy
Motor stops starting
Overload protection device
disengaged to protect the log
splitter from being damaged
Fails to split logs
Log is improperly positioned
Size of log exceeds the capacity of
the machine
Reduce log size before operating
Wedge cutting edge is blunt Sharpen cutting edge
Oil leaks Locate leak(s) and contact your dealer
Log pusher moves
jerkily, taking
unfamiliar noise or
vibrating a lot
Lack of hydraulic oil and excessive
air in the hydraulic system
dealer
Oil leaks around the
cylinder ram or from
other points
Air sealed in hydraulic system while
operating
Loosen bleed screw by some rotations before
operating the log splitter
Bleed screw is not tightened before
moving the log splitter
Tighten bleed screw up before moving the log
splitter
Oil drain screw loose
Hydraulic control valve assembly
and/or seal (s) worn
Contact your dealer
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
