www.scheppach.com
GB
|
25
17. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool fails to
work properly. If the problem persists after working through the list, please contact your nearest service workshop.
Malfunction Possible cause Remedy
The hydraulic pump does
not start
No electric power Check cable for electric power
Engage thermal switch inside the motor casing again
The column does not
move down
Low oil level
One of the levers not connected
Dirt in the rails Clean the column
Motor starts but column
does not move down
Wrong turning direction of 3-phase
motor
Check turning direction of motor and change
To Next Page
Loading...
