To Next PageTo Next PageWhat causes machined surface cracked with Scheppach HMS860?
If the machined surface is cracked when using your Scheppach Planer, it could be because the workpiece was machined against the grain; try machining it from the opposite direction. Also, you might be planing too much material at one pass, so machine the workpiece in several passes instead.
Why is the workpiece speed too low during thicknessing with my Scheppach HMS860 Planer?
If the workpiece speed is too low during thicknessing with your Scheppach Planer, it could be because the workpiece was machined against the grain, so clean the bench top and apply a thin coating of lubricant wax. Alternatively, too much material may have been planed at one pass, so set the lever for the thicknessing setting to the top position.
General| Power | 1500 W |
|---|---|
| Idle speed | 9000 RPM |
| Product color | Black, Blue, Grey |
| Dust extraction | Yes |
| AC input voltage | 230 - 240 V |
| Housing material | - |
| AC input frequency | 50 Hz |
| Planning width (max) | 204 mm |
Weight and Dimensions| Depth | 805 mm |
|---|---|
| Width | 445 mm |
| Height | 430 mm |
| Weight | 29500 g |
| Thicknessing table dimensions (W x D) | 270 x 251 mm |
Details the process and adjustments for surfacing wood pieces.
Details the process and adjustments for thicknessing wood pieces.
