To Next PageTo Next PageHow to prevent burnt areas on the cutting surface with Scheppach HS115?
Burnt areas on the cutting surface when using your Scheppach Saw can be due to a blunt or incorrect saw blade. You can have an authorised sharpening service sharpen the saw blade or replace it. Alternatively, you can replace the saw blade.
What to do if my Scheppach HS115 Saw motor does not start?
If your Scheppach Saw motor isn't starting, here are a few things to check: * First, examine the mains fuse and replace it if it's blown. * Second, if you're using an extension cable, make sure it's not defective. If it is, replace the extension cable. * Third, the connection to the motor switch might not be OK. In that case, have this checked by an electrician. * Finally, the motor or switch itself could be faulty. Have this checked by an electrician.
Why is my Scheppach Saw motor not supplying power and the fuse tripping?
If your Scheppach Saw motor isn't supplying power and the fuse is tripping, it could be due to a couple of reasons: 1. The cross section of your extension cable might be insufficient. Please refer to “Electrical connection” for the correct specifications. 2. The saw blade may be blunt, causing an overload. Try replacing the saw blade.
General| Type | Table Saw |
|---|---|
| Power | 2000 W |
| Blade Diameter | 254 mm |
| Blade Bore | 30 mm |
| Max Cutting Height at 90° | 80 mm |
| Max Cutting Depth at 90° | 80 mm |
| Cutting Height at 45° | 55 mm |
| Max Cutting Depth at 45° | 55 mm |
| Table Size | 640 x 487 mm |
| Weight | 22 kg |
| Motor Power | 2000 W |
