Scheppach IGT2500

www.scheppach.com
28
|
GB
General safety informations
1. Keep your work area tidy
• Disorder in the work area can lead to accidents.
2. Take environmental inuences into account
• Never work with the machine in enclosed rooms or in rooms with poor ventilation. If the motor
runs toxic gases are generated. These gases can be odourless and invisible.
• Do not expose the device to rain.
• Do not use electric tools in a damp or wet environment.
• Take care on your secure footing on uneven ground
• Make sure that the work area is well illuminated.
• Never use the machine in highly ammable vegetation or where re and explosion hazards exist.
• Provide a re extinguisher in drought conditions (re hazard).
3. Keep other persons away
• Do not allow other persons to work with the device especially children and young people.
4. Securely store unused electric tools
• Unused tools should be stored in a dry, elevated or closed location out of the reach of children.
5. Do not overload your device
• They work better and more safely in the specied output range.
6. Work in full consciousness
• Do not work with the device when you are under the inuence of alcohol, drugs, medication or
other substances which might compromise the vision, dexterity and judgment.
7. Use the device for its prescribed purpose
• Any other use than intended is deemed to be a case of misuse.
Safety notices for handling ammable fuels
1. WARNING!: Petrol is highly ammable:
2. Store fuel in containers specically designed for this purpose
3. Rell the gasoline tank only outdoors and do not smoke meanwhile.
4. Add fuel before starting the engine. Never remove the cap of fuel tank or add petrol while the en-
gine is running or when the engine is hot.
5. If petrol is spilled, do not attempt to start the engine but move the machine away from the area of
spillage and avoid creating any source of ignition until petrol vapours have dissipated. Replace all
fuel tank and container caps securely.
Adding fuel
• Always switch o󰀨 the engine before refuelling.
m Attention! Always open the fuel ller cap carefully to decompose slowly the excess pressure.
• Whilst working with the machine high temperatures can attain on the case. Allow the engine to cool
before refuelling.
m Attention! In case of insu󰀩cient cooling of the machine the fuel may ignite and lead to serious
burns during refueling.
• Make sure not to ll the tank with too much fuel. Immediately remove the fuel and clean the ma-
chine when spilling fuel.
• Always close the screw plug on the fuel tank in order to avoid loosening which may occure by vi-
brations when using the machine.