EasyManuals Logo

Scheppach IGT2500 User Manual

Scheppach IGT2500
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
www.scheppach.com
36
|
GB
Clean the lter elements with soapy water. After rinse the lter elements with clear water and allow
to dry thoroughly before retting.
Reassemble in reverse order
m WARNING
NEVER use gasoline or cleaning solvents with a low ash point to clean the air lter element. A re
or explosion could result.
Note
Never run the engine without or with a damaged air lter. Dirt gets so into the engine, causing serious
engine damage can occur. In this case, seller, and manufacturer disassociate from any warranty.
Check, clean and replace spark plug
Check the spark plug after 10 hours on dirt and grime. If necessary, clean it with a copper wire brush.
Maintenance the spark plug after 50 hours of operation
Open the spark plug cover (Fig. 9)
Remove the ignition cable with plug. (Fig. 9 Pos. D)
Remove any dirt from the base of the spark plug.
Use the enclosed spark plug wrench to remove the spark plug.
Check the spark plug visually. Remove any debris with a wire brush.
Look for discoloration on the top of the spark plug. By default, the color should be bright.
Check the spark plug gap. An acceptable gap width is 0.6 to 0.7 mm (Fig. 11)
Remove the spark plug carefully by hand.
If the plug has been inserted, tighten them with a spark plug wrench.
Attach the spark plug wire with connector on the spark plug.
NOTE
A loose spark plug can overheat and damage the engine. And overtightening the spark plug can
damage the threads in the cylinder head.
Service information
Please note that the following parts of this product are subject to normal or natural wear and that the
following parts are therefore also required for use as consumables.
Wear parts*: spark plug
* Not necessarily included in the scope of delivery!
Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and dust. Wipe the equipment
with a clean cloth or clean it with compressed air at low pressure.
We recommend that you clean your device after each use.
Clean the unit regularly with a damp cloth and some soft soap. Do not use cleaning agents or sol-
vents; they may damage the plastic parts of the appliance. Make sure that no water can get inside
the unit.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Scheppach IGT2500 and is the answer not in the manual?

Scheppach IGT2500 Specifications

General IconGeneral
Fuel typeGasoline
Noise level64.1 dB
Rated power2000 W
Rated voltage230 V
Ignition systemManual
Rated DC voltage12 V
Number of outlets2
Fuel tank capacity4.1 L
Engine displacement80 cm³
Engine number of strokes4
Castor wheelsNo
Product colorBlue
Oil tank capacity0.35 L
Carrying handle(s)Yes
Weight and Dimensions IconWeight and Dimensions
Depth520 mm
Width270 mm
Height440 mm
Weight17500 g

Related product manuals