www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
64
|
GB
The above-mentioned noise emission values were measured in accord-
ance with a standardised test procedure and can be used to compare
one power tool with another.
The above-mentioned noise emission values can also be used for the
preliminary assessment of exposure.
Warning:
• The noise emissions during the actual use of the power tool may dier
from the above-mentioned values depending on the power tool being
used, in particular on the type of workpiece being processed.
• Try to keep emissions as low as possible. For example: Limit your
working time. In this regard, all the operational cycle phases must be
taken into consideration (such as the times when the tool is switched
o or running idle).
7. Before starting the equipment
• Open the packaging and remove the device carefully.
• Remove the packaging material as well as the packaging and trans-
port bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport damage.
• If possible, store the packaging until the warranty period has expired.
DANGER
The device and packaging materials are not toys! Children must
not be allowed to play with plastic bags, lm and small parts!
There is a risk of swallowing and suocation!
• The equipment must be set up where it can stand securely. Secure the
machine on a workbench or a base frame with 4 screws (not included
in delivery) using the holes on the xed saw table (15).
• Pull out the pre-installed tilt protection (36) completely and secure it
with an Allen key (D) (g.2).
To Next Page
Loading...
Need help?
General